ECM > INSTALLATION

for Preparation Click here



1. INSTALL ECM


A111798

  1. Install the ECM with the bolt and 2 nuts.

    Torque:
    12.5 N*m{ 128 kgf*cm , 9 ft.*lbf }

  1. Connect the 4 connectors.



2. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY


B115417E01

  1. Attach the 2 hinges to install the door.



    B086888E02

  1. Push in the sides of the glove compartment door, as indicated by the arrows in the illustration. Then close the door to engage it to the 2 stoppers.



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


4. READ REGISTERED DATA


5. START ENGINE

NOTICE:
After replacing the ECM, the new ECM needs initialization (see page )



6. PERFORM INITIALIZATION

  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.