GENERATOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE AIR CLEANER ASSEMBLY


A099628E02

  1. Disconnect the MAF meter connector and remove the clamp.

  1. Loosen the hose clamp of the compressor inlet elbow.

  1. Remove the 2 bolts and air cleaner.



3. REMOVE FAN AND GENERATOR V BELT

  1. Using the pulley set bolt of the tensioner, rotate the tensioner pulley clockwise to loosen the belt's tension. Then remove the V belt.



4. REMOVE GENERATOR ASSEMBLY


A111821

  1. Remove the nut and generator wire.

  1. Disconnect the generator connector.

  1. Remove the 2 bolts, adjusting bar and generator.