STARTER > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE FRONT FENDER SEAL

  1. Remove the 5 clips and seal.



3. REMOVE STARTER ASSEMBLY


A111843

  1. Disconnect the starter connector.

  1. Remove the nut and disconnect the starter wire.

  1. A/T:
    Remove the 2 bolts and A/T dipstick.

  1. M/T:
    Remove the clutch release cylinder.



    A111844E01

  1. A/T:
    Remove the 2 nuts, bolt, ground cable and starter.

  1. M/T:
    Remove the nut, bolt, ground cable and starter.