STARTER > INSTALLATION

for Preparation Click here



1. INSTALL STARTER ASSEMBLY


    A111844E01

  1. A/T:
    Install the starter and ground cable with the 2 nuts and bolt.

  1. M/T:
    Install the starter and ground cable with the nut and bolt.

    Torque:
    68 N*m{ 693 kgf*cm , 50 ft.*lbf }

  1. Install the starter wire to terminal 30 with the nut.

    Torque:
    9.8 N*m{ 100 kgf*cm , 7 ft.*lbf }

  1. Connect the starter connector.

  1. A/T:
    Install the A/T oil dipstick with the 2 bolts.

  1. M/T:
    Install the clutch release cylinder.



2. INSTALL FRONT FENDER SEAL

  1. Install the seal with the 5 clips.



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


4. PERFORM INITIALIZATION

  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.