DTC    P2769/64    Short in Torque Converter Clutch Solenoid Circuit (Shift Solenoid Valve SL)

DTC    P2770/64    Open in Torque Converter Clutch Solenoid Circuit (Shift Solenoid Valve SL)

for Preparation Click here


DESCRIPTION

The shift solenoid valve SL is turned ON and OFF by signals from the TCM to control the hydraulic pressure acting on the lock-up relay valve, which then controls operation of the lock-up clutch.

DTC No.
DTC Detection Condition
Trouble Area
P2769/64
TCM detects short in shift solenoid valve SL circuit (once) when shift solenoid valve SL is operated (1 trip detection logic)
  1. Short in shift solenoid valve SL circuit
  2. Shift solenoid valve SL
  3. TCM
P2770/64
TCM detects open in shift solenoid valve SL circuit (once) when shift solenoid valve SL is not operated (1 trip detection logic)
  1. Open in shift solenoid valve SL circuit
  2. Shift solenoid valve SL
  3. TCM
Fail-safe function:
If the TCM detects a malfunction, it turns the shift solenoid valve SL OFF.

MONITOR DESCRIPTION

Torque converter lock-up is controlled by the TCM based on engine rpm, engine load, engine temperature, vehicle speed, transmission temperature, and shift position selection. The TCM determines the lock-up status of the torque converter by comparing the engine rpm (NE) to the input rpm (NC0). The TCM calculates the actual transmission gear by comparing the input rpm (NC0) to the output rpm (SP2). When conditions are appropriate, the TCM requests "lock-up" by applying control voltage to the shift solenoid valve SL. When the shift solenoid valve SL is opened, the shift solenoid valve SL applies pressure to the lock-up relay valve and locks the torque converter clutch. If the TCM detects an open or short in the shift solenoid valve SL circuit, the TCM interprets this as a fault in the shift solenoid valve SL or its circuit. The TCM will illuminate the MIL and store a DTC.

WIRING DIAGRAM


A110993E04


INSPECTION PROCEDURE

1.INSPECT TRANSMISSION WIRE (SHIFT SOLENOID VALVE SL)


    G022892E03

  1. Disconnect the E1 wire connector.

  1. Measure the resistance of the transmission wire.

    Standard resistance:
    Tester Connection
    		Condition
    		Specified Condition
    7 (S3) - Body ground
    		20°C (68°F)
    		11 to 15 Ω



NG
Go to step 3
OK


2.CHECK WIRE HARNESS (SHIFT SOLENOID VALVE SL - TCM)


    F045523E07

  1. Disconnect the T19 TCM connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    		Condition
    		Specified Condition
    T19-16 (SL) - Body ground
    		20°C (68°F)
    		11 to 15 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE TCM 

3.INSPECT SHIFT SOLENOID VALVE SL
G034613E01

  1. Remove the shift solenoid valve SL.

  1. Measure the resistance between the solenoid valve terminal and solenoid valve body.

    Standard resistance:
    11 to 15 Ωat 20°C (68°F)

  1. Connect the battery's positive (+) lead to the terminal of the solenoid connector, and the negative (-) lead to the solenoid body.

    OK:
    Solenoid makes operating noise.



NG
REPLACE SHIFT SOLENOID VALVE SL
OK

REPLACE TRANSMISSION WIRE