HORN SYSTEM > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT INTEGRATION RELAY (HORN RELAY)


G034545E02

  1. Using a screwdriver, detach the 2 claws and disconnect the integration relay from the engine room junction block.

    HINT:
    Tape the screwdriver tip before use.



    A099733E02

  1. Measure the voltage of the HORN relay.

    Standard voltage:
    Tester Connection
    		Condition
    		Specified Condition
    1I-8 - Body ground
    		Horn button switch ON
    		10 to 14 V

    If the result is not as specified, replace the integration relay.