REAR BUMPER (for Flat Type) > DISASSEMBLY

for Preparation Click here



1. REMOVE LICENSE PLATE LIGHT ASSEMBLY


B085211E01

  1. Detach the 4 claws and remove 2 lights.



2. REMOVE REAR BUMPER PLATE


B085213E01

  1. Using a screwdriver, detach the 13 claws and remove the bumper plate.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE REAR BUMPER PLATE LH


B085214E01

  1. Using a screwdriver, detach the 2 claws and remove the plate.

    HINT:
    Tape the screwdriver tip before use.



4. REMOVE REAR BUMPER PLATE RH

HINT:
Use the same procedures described for the LH side.



5. REMOVE REAR BUMPER BAR PLATE


B086209E01

  1. Using a heat light, heat the bumper bar plate.

    Standard:
    Item
    		Heating Temperature
    Rear bumper bar plate
    		20 to 30°C (68 to 86°F)

    NOTICE:
    Do not heat the bumper bar plate excessively.

  1. Pull off the bumper bar plate by cutting the double-sided tape with a knife.

    NOTICE:
    Be careful not to damage the bumper bar.

  1. Using a screwdriver, detach the 12 claws and remove the bumper bar plate from the bumper bar.

    HINT:
    Tape the screwdriver tip before use.