REAR BUMPER (for Flat Type) > INSTALLATION

for Preparation Click here



1. INSTALL REAR BUMPER ARM LH

  1. Install the arm with the 2 bolts.

    Torque:
    45 N*m{ 459 kgf*cm , 33 ft.*lbf }



2. INSTALL REAR BUMPER ARM RH

  1. Install the arm with the 2 bolts.

    Torque:
    45 N*m{ 459 kgf*cm , 33 ft.*lbf }



3. INSTALL REAR BUMPER BAR


B085210E01

  1. Install the bumper with the 4 bolts.

    Torque:
    45 N*m{ 459 kgf*cm , 33 ft.*lbf }



    B085212E01

  1. Attach the 4 license plate light clamps.

  1. Connect the 2 connector.



4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


5. PERFORM INITIALIZATION

  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.