FRONT BUMPER > DISASSEMBLY

for Preparation Click here



1. REMOVE NO. 1 RADIATOR GRILLE RETAINER

  1. Remove the 5 screws and retainer.



2. REMOVE RADIATOR GRILLE NAME PLATE (for 1GR-FE)


B112761E01

  1. Remove the 2 spring nuts.

  1. Using a heat light, heat the name plate.

    Standard:
    Item
    		Heating Temperature
    Name Plate
    		20 to 30°C (68 to 86°F)

    NOTICE:
    Do not heat the name plate excessively.

  1. Pull off the name plate by cutting the double-sided tape with a knife.

    NOTICE:
    Be careful not to damage the radiator grille.



3. REMOVE RADIATOR GRILLE EMBLEM


B085201E01

  1. Using a screwdriver, detach the 3 claws and remove the emblem from the radiator grille.



4. REMOVE FRONT BUMPER EXTENSION LH (w/ Front Bumper Extension)


B085198E01

  1. Using a screwdriver, detach the 6 clips and remove the extension.

    HINT:
    Tape the screwdriver tip before use.



5. REMOVE FRONT BUMPER EXTENSION RH (w/ Front Bumper Extension)

HINT:
Use the same procedures described for the LH side.



6. REMOVE FRONT BUMPER HOLE COVER LH

  1. Using a screwdriver, remove the clip and hole cover.

    HINT:
    Tape the screwdriver tip before use.



7. REMOVE FRONT BUMPER HOLE COVER RH

HINT:
Use the same procedures described for the LH side.



8. REMOVE NO. 2 FRONT BUMPER EXTENSION INSERT LH

  1. Remove the screw and extension insert.



9. REMOVE NO. 2 FRONT BUMPER EXTENSION INSERT RH

  1. Remove the screw and extension insert.