FORWARD CLUTCH > INSPECTION

for Preparation Click here



1. INSPECT PISTON STROKE OF FORWARD CLUTCH


AT07843E01

  1. Using SST and a dial indicator, measure the direct clutch piston stroke while applying and releasing compressed air (392 kPa (4.0 kgf/cm2, 57 psi)).

    SST
    09350-30020   (09350-06120)

    Piston thickness:
    0.60 to 1.00 mm (0.024 to 0.039 in.)

    If the piston stroke is not as specified, parts may have been assembled incorrectly. Check and reassemble again.

    HINT:
    1. If the piston stroke is still not as specified, select another flange.
    2. There are 8 different flange thicknesses.

      Piston stroke:
      No.
      		Thickness
      		No.
      		Thickness
      90
      		3.0 mm (0.118 in.)
      		94
      		3.8 mm (0.150 in.)
      91
      		3.2 mm (0.126 in.)
      		95
      		4.0 mm (0.157 in.)
      92
      		3.4 mm (0.134 in.)
      		96
      		4.2 mm (0.165 in.)
      93
      		3.6 mm (0.142 in.)
      		97
      		4.4 mm (0.173 in.)



2. INSPECT FORWARD CLUTCH DISC


D001216E02

  1. Replace all discs if one of the following problems is present: 1) a disc, plate or flange is worn or burnt, 2) the lining of a disc is peeled off or discolored, or 3) grooves or printed numbers have even a little bit of damage.

    NOTICE:
    Before assembling new discs, soak them in ATF for at least 15 minutes.



3. INSPECT FORWARD CLUTCH PISTON


D001424E01

  1. Check that the check ball is free by shaking the piston.

  1. Check that the valve does not have leaks by applying low-pressure compressed air.



4. INSPECT FORWARD CLUTCH DRUM


AT08171E01

  1. Using a dial indicator, measure the inside diameter of the forward clutch drum bush.

    Maximum inside diameter:
    24.08 mm (0.948 in.)

    If the inside diameter is greater than the maximum, replace the forward clutch drum.