OIL PUMP > DISASSEMBLY

for Preparation Click here



1. REMOVE FRONT OIL PUMP BODY O-RING


D027950E01

  1. Remove the O-ring from the oil pump assembly.



2. FIX OIL PUMP ASSEMBLY


D027951E03

  1. Place the oil pump body on the torque converter clutch.



3. REMOVE CLUTCH DRUM OIL SEAL RING


D027952E05

  1. Remove the 3 oil seal rings.



4. REMOVE STATOR SHAFT ASSEMBLY


D027953E01

  1. Remove the 14 bolts, and then remove the stator shaft from the oil pump body.



5. REMOVE FRONT OIL PUMP BODY O-RING


D027963E01

  1. Remove the O-ring from the oil pump body.

  1. Remove the oil pump body from the torque converter clutch.



6. INSPECT FRONT OIL PUMP BODY SUB-ASSEMBLY


D027954E01

  1. Using a dial indicator, measure the inside diameter of the oil pump body bushing.

    Maximum inside diameter:
    38.188 mm (1.504 in.)

    1. If the inside diameter is greater than the maximum, replace the oil pump body.



7. INSPECT STATOR SHAFT ASSEMBLY


D027955E01

  1. Using a dial indicator, measure the inside diameter of the stator shaft bushing.

    Maximum inside diameter:
    Front side:
    21.577 mm (0.850 in.)
    Rear side:
    32.08 mm (1.263 in.)

    1. If the inside diameter is grater than the maximum, replace the stator shaft.



8. INSPECT CLEARANCE OF OIL PUMP ASSEMBLY


9. REMOVE FRONT OIL PUMP DRIVE GEAR


D027958E01


10. REMOVE FRONT OIL PUMP DRIVEN GEAR


D027959E01


11. REMOVE FRONT OIL PUMP OIL SEAL


D027960E01

  1. Using a screwdriver, remove the oil seal.

    NOTICE:
    Be careful not to damage the bushing and oil pump body.