HOOD LOCK CONTROL CABLE ASSEMBLY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE RADIATOR GRILLE


B085203E01

  1. Using a clip remover, remove the 2 clips.

  1. Remove the 2 screws.

  1. Pull the radiator grille in the direction indicated by the arrow in the illustration to detach the 5 claws and remove the radiator grille.



3. REMOVE HOOD LOCK ASSEMBLY


B112848E02

  1. Remove the radiator grille.

  1. w/ Hood courtesy switch:
    Detach the clamp and disconnect the connector.

  1. Remove the 3 bolts.

  1. Disconnect the cable and remove the lock.



4. REMOVE HOOD LOCK CONTROL CABLE ASSY

  1. Remove the open lever.

  1. Remove the grommet from the vehicle body.



  1. Remove the cable from the clamps as shown in the illustration.


    B112847E04