VANE PUMP (for TR Series Engine) > REMOVAL

for Preparation Click here


NOTICE:
  1. When using a vise, do not overtighten it.
  2. When installing the parts indicated by arrows, coat them with power steering fluid (Click here).



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. DRAIN POWER STEERING FLUID


3. REMOVE FAN AND GENERATOR V BELT


4. DISCONNECT RETURN HOSE


G038601E01

  1. Remove the clip and disconnect the hose.



5. DISCONNECT PRESSURE FEED TUBE ASSEMBLY


G038602E01

  1. Remove the union bolt and disconnect the pressure feed tube from the vane pump.

  1. Remove the gasket from the pressure feed tube.



6. REMOVE VANE PUMP ASSEMBLY


G038598E01

  1. Disconnect the connector from the power steering oil pressure switch.



    G028304E01

  1. Remove the 2 bolts and vane pump.



7. REMOVE VANE PUMP OIL RESERVOIR CAP SUB-ASSEMBLY


8. REMOVE VANE PUMP OIL RESERVOIR SUB-ASSEMBLY

  1. Remove the 3 bolts and oil reservoir from the front vane pump housing.

  1. Using a screwdriver, remove the O-ring from the oil reservoir.