EXHAUST PIPE > REMOVAL

for Preparation Click here


CAUTION:
  1. Wear protective gloves when removing the exhaust pipe assembly.
  2. The exhaust pipe assembly is extremely hot immediately after the engine has stopped.
  3. Confirm that the exhaust pipe assembly has cooled down before removing it.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag activation.



2. REMOVE TAILPIPE ASSEMBLY

  1. Remove the 2 bolts and 2 nuts.

  1. Disconnect the tailpipe from the center pipe and remove the gasket.

  1. Remove the tailpipe from the pipe support.



3. REMOVE CENTER EXHAUST PIPE ASSEMBLY

  1. Remove the 2 bolts and 2 nuts.

  1. Disconnect the center pipe from the front pipe and remove the gasket.

  1. Remove the center pipe from the 3 pipe supports.



4. REMOVE HEATED OXYGEN SENSOR


    G039109E01

  1. Disconnect the sensor connector.

  1. Detach the 3 wire clamps.



    G039112E01

  1. Using SST, remove the sensor.

    SST
    09224-00010  



5. REMOVE FRONT EXHAUST PIPE ASSEMBLY

  1. Remove the 2 bolts and 2 compression springs.

  1. Disconnect the front pipe from the outlet pipe and remove the gasket.

  1. Remove the front pipe from the pipe support.