AIR CONDITIONING CONTROL ASSEMBLY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE HEATER CONTROL KNOB


B088680E02

  1. Remove the 3 control knobs.



3. REMOVE FRE/REC CONTROL KNOB


B111103E01

  1. Remove the control knob.



4. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY CENTER


B113048E01

HINT:
To prevent the clips from falling, horizontally pull out the panel. Hold both sides of the panel in the locations indicated by the arrows in the illustration.

  1. Remove the screw <C>.

  1. Detach the 6 claws and 4 clips.

  1. NOTICE:
    Make sure the center registers are not removed.

    Disconnect all connectors and remove the panel.



5. REMOVE AIR CONDITIONING CONTROL ASSEMBLY


    I043226E01

  1. Detach the 2 claws and disconnect the A/C control.



    E111651E01

  1. Detach the 2 claws and disconnect the air inlet damper control cable.

  1. Disconnect the connector.



    E111652E01

  1. Detach the 2 claws and disconnect the heater control cable.

  1. Detach the 2 claws and disconnect the air mix damper control cable.

  1. Remove the A/C control.