AIR CONDITIONING AND BLOWER UNIT > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY UPPER |
Remove instrument panel sub-assembly upper (Click here).
| 3. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY LOWER |
Remove instrument panel sub-assembly lower (Click here).
| 4. REMOVE NO. 2 HEATER TO REGISTER DUCT |
![]() |
Remove the clip and duct.
| 5. REMOVE NO. 1 HEATER TO REGISTER DUCT |
![]() |
Detach the 3 claws and remove the duct.
| 6. REMOVE NO. 3 HEATER TO REGISTER DUCT |
![]() |
Detach the 4 claws and remove the duct.
| 7. REMOVE NO. 1 INSTRUMENT PANEL BRACE SUB-ASSEMBLY |
![]() |
Remove the 3 nuts, 2 bolts, 2 clamps and instrument panel brace.
Disconnect the connectors and remove the instrument panel junction block.
| 8. REMOVE NO. 1 COOLER UNIT DRAIN HOSE |
![]() |
Remove the drain hose.
| 9. DISCONNECT STEERING COLUMN ASSEMBLY |
Remove the 3 bolts and pull out the steering column together with the steering sliding w/ coupling yoke.
| 10. REMOVE ECM |
![]() |
Disconnect the 4 connectors.
Remove the bolt, 2 nuts and ECM.
| 11. REMOVE INSTRUMENT PANEL REINFORCEMENT |
![]() |
Disconnect the clamp.
![]() |
Disconnect the connector, 3 clamps and wire harness.
![]() |
Remove the 2 bolts and disconnect the ground wire from the instrument panel reinforcement.
![]() |
Remove the grommet from the vehicle body.
Release the 12 clamps.
Disconnect the connectors.

Remove the 3 bolts.

Remove the 7 bolts and instrument panel reinforcement.

| 12. REMOVE AIR CONDITIONING AND BLOWER ASSEMBLY |
![]() |
Remove the bolt, nut and A/C unit.