HEATER BLOWER MOTOR RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT RELAY (Marking: HTR)


B083458E01

  1. Measure the resistance of the HTR relay.

    Standard resistance:
    Tester Connection
    		Specified Condition
    3 - 4
    		Below 1 Ω
    3 - 5
    		10 kΩ or higher
    3 - 5
    		Below 1 Ω
    (when battery voltage is applied to terminals 1 and 2)

    If the result is not as specified, replace the relay.