SEAT BELT WARNING SYSTEM > PROBLEM SYMPTOMS TABLE

for Preparation Click here

HINT:

Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.


Symptom	Suspected area	See page
Driver seat belt warning light does not blink (ignition switch is ON and driver side buckle switch is ON (seat belt unfastened))	MET fuse	Click here
	Front seat inner belt assembly (driver side)	Click here
	Combination meter assembly	Click here
	Wire harness
Passenger seat belt warning light does not blink (ignition switch is ON, occupant detection sensor is ON and passenger side buckle switch is ON (seat belt unfastened))	ECU-IG & GAUGE fuse	Click here
	Front seat inner belt assembly (passenger side)	Click here
	Occupant detection sensor	Click here
	Accessory meter assembly	Click here
	Wire harness