METER / GAUGE SYSTEM > DIAGNOSIS SYSTEM

for Preparation Click here



DESCRIPTION
Combination meter data and the Diagnostic Trouble Codes (DTCs) can be read through the Data List Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning, use the intelligent tester to check for malfunctions and perform repairs.

CHECK DLC3
The vehicle's ECM uses the ISO 14230 (M-OBD) communication protocol. The terminal arrangement of the DLC3 complies with ISO 15031-03 and matches the ISO 14230 format.
If the result is not as specified, the DLC3 may have a malfunction. Repair or replace the harness and connector.
A082779E50
A099015E03

Symbols (Terminal No.)
Terminal Description
Condition
Specified Condition
SIL (7) - SG (5)
Bus "+" line
During transmission
Pulse generation
CG (4) - Body ground
Chassis ground
Always
Below 1 Ω
SG (5) - Body ground
Signal ground
Always
Below 1 Ω
BAT (16) - Body ground
Battery
Always
11 to 14 V

HINT:
Connect the cable of the intelligent tester to the DLC3, turn the ignition switch ON and attempt to use the tester. If the display indicates that a communication error has occurred, there is a problem either with the vehicle or with the tester.

  1. If communication is normal when the tester is connected to another vehicle, inspect the DLC3 on the original vehicle.
  2. If communication is still not possible when the tester is connected to another vehicle, the problem may be in the tester itself. Consult the Service Department listed in the tester's instruction manual.