METER / GAUGE SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use these procedures to troubleshoot the meter / gauge system.
  2. *: Use the intelligent tester.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.PROBLEM SYMPTOMS TABLE

      Result 
      Result
      		Proceed to
      Fault is not listed in problem symptoms table
      		A
      Fault is listed in problem symptoms table
      		B


    		B.
    Go to step 5
    A


    4.OVERALL ANALYSIS AND TROUBLESHOOTING*

    1. Terminals of ECU (Click here)

    2. Data List/Active Test (Click here)

    3. On-vehicle Inspection (Click here)


    NEXT


    5.REPAIR OR REPLACE

      NEXT


      6.CONFIRMATION TEST

        NEXT

        END