COUNTER GEAR AND REVERSE IDLER GEAR > REMOVAL

for Preparation Click here


HINT:
COMPONENTS: Click here.



1. REMOVE NO. 2 COUNTER GEAR FRONT BEARING SNAP RING


D026119E01

  1. Using a snap ring expander, remove the snap ring from the counter gear.



2. REMOVE COUNTER GEAR FRONT BEARING


D026121E01

  1. Using SST and a press, press out the front bearing from the counter gear.

    SST
    09950-00020  
    09950-60010   (09951-00220)
    09950-70010   (09951-07100)



3. INSPECT COUNTER GEAR


C086509E01

  1. Using a micrometer, measure the outside diameter of the counter gear as shown in the illustration.

    Standard outside diameter:
    29.984 to 30.000 mm (1.1805 to 1.1811 in.)

    Minimum outside diameter:
    29.984 mm (1.1805 in.)

    If the outside diameter is less than the minimum, replace the counter gear with a new one.