FRONT WASHER MOTOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE WASHER INLET SUB-ASSEMBLY


B084991

  1. Remove the clip.

  1. Pull the washer inlet of the washer jar and pump upward. Then remove it from the windshield washer jar and pump.



3. REMOVE FRONT FENDER LINER LH


B085207E01

  1. Remove the screw.

  1. Using a clip remover, remove the 3 clips.

  1. Partially remove the fender liner.

    HINT:
    It is not necessary to fully remove the fender liner. Partially remove it so that the bumper cover can be removed in a later step.



4. DRAIN WASHER FLUID

  1. Remove the washer hose from the windshield washer motor and pump, and drain the washer fluid.



5. REMOVE WINDSHIELD WASHER JAR ASSEMBLY


B084992

  1. Disconnect the connector.

  1. Remove the clip and 3 bolts. Then remove the washer jar and pump.



6. REMOVE WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY


B084993

  1. Pull out the washer motor and pump from the packing of the washer jar.