FRONT WIPER MOTOR AND LINK > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE FRONT WIPER ARM HEAD CAP

  1. Remove the 2 caps.



3. REMOVE FRONT WIPER ARM & BLADE ASSEMBLY LH


B087995

  1. Remove the nut and arm & blade.



4. REMOVE FRONT WIPER ARM & BLADE ASSEMBLY RH


B087994

  1. Remove the nut and arm & blade.



5. REMOVE HOOD TO COWL TOP SEAL


B087996E02

  1. Detach the 9 clips and remove the seal.



6. REMOVE COWL TOP VENTILATOR LOUVER LH


B087997E02

  1. Detach the 4 claws and remove the louver.



7. REMOVE COWL TOP VENTILATOR LOUVER RH


B087998E02

  1. Detach the 5 claws and remove the louver.



8. REMOVE WINDSHIELD WIPER MOTOR & LINK ASSEMBLY


B087999

  1. Disconnect the connector.

  1. Remove the 2 bolts.

  1. Move the wiper cushion in the direction shown by the arrow in the illustration to detach the wiper cushion from the body, and remove the wiper motor & link.



9. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY


    B090241E01

  1. Using a screwdriver, disconnect the 2 rods of the wiper link from the wiper motor as shown in the illustration.

    HINT:
    Tape the screwdriver tip before use.



    B090242

  1. Using a T30 ''torx'' socket, remove the 2 bolts and wiper motor.