FRONT WIPER MOTOR AND LINK > INSTALLATION

for Preparation Click here



1. INSTALL WINDSHIELD WIPER MOTOR ASSEMBLY


B090242

  1. Using a T30 ''torx'' socket, install the wiper motor with the 2 bolts.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

  1. Apply MP grease to the sliding parts of the wiper motor and the 2 rods of the wiper link.

  1. Connect the 2 rods of the wiper link to the wiper motor.



2. INSTALL WINDSHIELD WIPER MOTOR & LINK ASSEMBLY


B088000

  1. Move the wiper motor & link in the direction shown by the arrow in the illustration to attach the wiper cushion to the body, and install the wiper motor & link.

  1. Install the 2 bolts.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

  1. Connect the connector.



3. INSTALL COWL TOP VENTILATOR LOUVER LH


B087998E03

  1. Attach the 5 claws and install the louver.



4. INSTALL COWL TOP VENTILATOR LOUVER RH


B087997E03

  1. Attach the 4 claws and install the louver.



5. INSTALL HOOD TO COWL TOP SEAL


B087996E03

  1. Attach the 9 clips and install the seal.



6. INSTALL FRONT WIPER ARM & BLADE ASSEMBLY RH


    E058837E07

  1. Stop the wiper motor at the automatic stop position.

  1. Clean the wiper arm serration with a round file or equivalent.

  1. Clean the wiper pivot serration with a wire brush.



    B088002E01

  1. Install the arm & blade with the nut. Make sure that the arm & blade comes to the position shown in the illustration.

    Torque:
    19.6 N*m{ 200 kgf*cm , 14 ft.*lbf }

    HINT:
    Hold down the arm hinge with your hand while tightening the nut.



7. INSTALL FRONT WIPER ARM & BLADE ASSEMBLY LH


    E058837E07

  1. Clean the wiper arm serration with a round file or equivalent.

  1. Clean the wiper pivot serration with a wire brush.



    B088536E01

  1. Install the arm & blade with the nut. Make sure that the arm & blade comes to the position shown in the illustration.

    Torque:
    19.6 N*m{ 200 kgf*cm , 14 ft.*lbf }

    HINT:
    Hold down the arm hinge with your hand while tightening the nut.

  1. Operate the front wipers while spraying water or washer fluid on the windshield. Ensure that there is no interference between the blades and pillar.



8. INSTALL FRONT WIPER ARM HEAD CAP

  1. Install the 2 caps.



9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


10. PERFORM INITIALIZATION

  1. Perform initialization (Click here ).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.