ROOM LIGHT ASSEMBLY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE NO. 1 ROOM LIGHT LENS


B085012

  1. Using a screwdriver, detach the 4 claws and remove the lens.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE NO. 1 ROOM LIGHT ASSEMBLY


B085593

  1. Remove the 2 screws and room light.

  1. Disconnect the lamp connector.



4. REMOVE NO. 1 ROOM LIGHT BULB

  1. Remove the bulb from the room light.