LICENSE PLATE LIGHT ASSEMBLY > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH and LH side.
  2. The procedures listed below are for the LH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE LICENSE PLATE LIGHT ASSEMBLY


B087093E03

  1. Detach the 2 claws and remove the license plate light.

  1. Disconnect the connector.



3. REMOVE LICENSE PLATE LIGHT BULB


B085011

  1. Turn the bulb/socket unit in the direction indicated by the arrow and pull to remove it.

  1. Remove the bulb from the socket.