REAR COMBINATION LIGHT ASSEMBLY > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH and LH side.
  2. The procedures listed below are for the LH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE REAR COMBINATION LIGHT ASSEMBLY


B085008E01

  1. Remove the 2 screws.

  1. Detach the 2 clips and remove the lamp.

  1. Disconnect the connector.



3. REMOVE REAR COMBINATION LIGHT BULB


B085009

  1. Turn the 3 bulbs in the direction indicated by the arrows and pull to remove them.