REAR COMBINATION LIGHT ASSEMBLY > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the RH and LH side.
  2. The procedures listed below are for the LH side.



1. INSTALL REAR COMBINATION LIGHT BULB


B113209

  1. Turn the 3 bulbs in the direction indicated by the arrows to install them.



2. INSTALL REAR COMBINATION LIGHT ASSEMBLY


B085008E01

  1. Connect the connector.

  1. Attach the rear combination light with the 2 clips.

  1. Install the 2 screws.



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


4. PERFORM INITIALIZATION

  1. Perform initialization (Click here ).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.