FRONT AXLE HUB (for 4WD) > INSTALLATION

for Preparation Click here

HINT:

1. Use the same procedures for the RH side and LH side.
   
2. The procedures listed below are for the LH side.
   
3. A bolt without a torque specification is shown in the standard bolt chart (Click here).
   

1. Using a brass bar and hammer, tap in a new oil seal.
   

   NOTICE:

   Do not damage the spacer.

1. Using SST and a press, press a new bearing into the axle hub.
   

   SST

   09649-17010  
   

1. w/ ABS:
   Install the spacer and ABS rotor to the axle hub.
   

2. w/o ABS:
   Install the 2 spacers to the axle hub.
   

3. Apply the MP grease to a new O-ring.
   

4. Install the new O-ring to the axle hub.
   

5. Install the dust cover and axle hub to the steering knuckle with the 4 bolts.
   

   Torque:

   80 N*m{ 816 kgf*cm , 59 ft.*lbf }

1. Install the hub nut.
   

   Torque:

   235 N*m{ 2,396 kgf*cm , 173 ft.*lbf }

2. Install the adjusting cap and a new cotter pin.
   

   NOTICE:

   If the holes for the cotter pin are not aligned, tighten the nut an additional 60°.

1. Install the disc brake caliper with the 2 bolts.
   

   Torque:

   123 N*m{ 1,254 kgf*cm , 91 ft.*lbf }

2. Install the brake tube bracket to the steering knuckle with the bolt.
   

   Torque:

   29 N*m{ 296 kgf*cm , 21 ft.*lbf }

3. Using SST, connect the brake tube to the disc brake caliper.
   

   SST

   09023-00101  
   

   Torque:

   15 N*m{ 155 kgf*cm , 11 ft.*lbf } for use without SST

   14 N*m{ 143 kgf*cm , 10 ft.*lbf } for use with SST

   HINT:

   Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).

1. Install the speed sensor with the bolt.
   

   Torque:

   8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

2. Connect the 2 clamps.
   

3. Install the speed sensor wire harness to the steering knuckle with the bolt.
   

   Torque:

   13 N*m{ 133 kgf*cm , 10 ft.*lbf }

Torque:

105 N*m{ 1,071 kgf*cm , 77 ft.*lbf }

1. Check ABS speed sensor signal (Click here).