INPUT SHAFT > INSTALLATION

for Preparation Click here



1. INSTALL INPUT SHAFT FRONT BEARING


C086534E01

  1. Using SST and a press, press in a new front bearing.

    SST
    09316-60011  



    D033850E01

  1. Select a snap ring that will allow minimal axial play.

    Standard clearance:
    0.10 mm (0.0039 in.) or less

    Front bearing shaft snap ring thickness:
    Mark
    		Thickness
    0
    		2.05 to 2.10 mm (0.0807 to 0.0827 in.)
    1
    		2.10 to 2.15 mm (0.0827 to 0.0847 in.)
    2
    		2.15 to 2.20 mm (0.0847 to 0.0866 in.)
    3
    		2.20 to 2.25 mm (0.0866 to 0.0886 in.)
    4
    		2.25 to 2.30 mm (0.0886 to 0.0906 in.)
    5
    		2.30 to 2.35 mm (0.0906 to 0.0925 in.)



    D033851E01

  1. Using a snap ring expander, install the snap ring.



2. INSTALL INPUT SHAFT BEARING


C086536E01

  1. Coat the 13 input shaft bearings with MP grease, and install them to the input shaft.



3. INSTALL NO. 2 SYNCHRONIZER RING


C067214E01

  1. Coat the No. 2 synchronizer ring with gear oil, and install it to the input shaft.