REAR SHOCK ABSORBER (for 4WD) > INSTALLATION

for Preparation Click here



1. INSTALL REAR SHOCK ABSORBER ASSEMBLY


C113168

  1. Install the 2 washers to the axle housing.

  1. Install 4 new bushes to the absorber.

  1. Install the absorber (with the 4 bushes) to the U bolt seat and frame.

  1. Install the 2 washers.

  1. Temporarily tighten the 2 bolts.



2. INSTALL REAR WHEEL

  1. Install the wheel.

    Torque:
    105 N*m{ 1,070 kgf*cm , 77 ft.*lbf }



3. STABILIZE SUSPENSION

  1. Lower the vehicle.

  1. Press down on the vehicle several times to stabilize the suspension.



4. TIGHTEN REAR SHOCK ABSORBER BOLT

  1. Tighten the 2 bolts.

    Torque:
    105 N*m{ 1,070 kgf*cm , 77 ft.*lbf }