REAR SHOCK ABSORBER (for 2WD) > DISPOSAL

for Preparation Click here



1. DISPOSE OF REAR SHOCK ABSORBER ASSEMBLY


F049964E01

  1. Fully extend the shock absorber rod, and clamp it in a vise at an angle.

  1. Using a drill or similar tool, gradually make a hole in area A to discharge the gas inside of the absorber.

    CAUTION:
    As metal debris may be blown outward by the gas, you must:
    1. Wear protective glasses.
    1. Cover the area being cut.

    NOTICE:
    The gas is colorless, odorless and harmless.