FRONT STABILIZER BAR > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  1. The procedures listed below are for the LH side.
  1. A bolt without a torque specification is shown in the standard bolt chart.



1. REMOVE FRONT WHEEL


2. REMOVE FRONT STABILIZER LINK ASSEMBLY LH


F050281E01

  1. Remove the 2 nuts and stabilizer link.

    HINT:
    If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud in place.



3. REMOVE FRONT STABILIZER LINK ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.



4. REMOVE FRONT STABILIZER BRACKET


F050282E01

  1. Remove the 4 bolts and 2 brackets.



5. REMOVE FRONT NO. 1 STABILIZER BAR BUSH

  1. Remove the 2 bushes.



6. REMOVE FRONT STABILIZER BAR

  1. Remove the stabilizer bar front from the vehicle body.