FRONT SUSPENSION LOWER ARM (for 2WD) > INSTALLATION

for Preparation Click here

1. Temporarily install the lower arm with the 2 camber adjusting cams, No. 1 and No. 2 camber adjusting cams and 2 nuts.
   

2. Align the matchmarks on the No. 1 camber adjusting cam and No. 2 camber adjusting cam. Temporarily tighten the nuts.
   

3. Install the ball joint attachment with the nut and a new cotter pin.
   

   Torque:

   140 N*m{ 1,428 kgf*cm , 103 ft.*lbf }

4. Install the ball joint attachment with the 2 bolts.
   

   Torque:

   160 N*m{ 1,632 kgf*cm , 118 ft.*lbf }

1. Install the shock absorber with coil spring with the bolt, and temporarily install the nut.
   

1. Install the front wheel.
   

   Torque:

   152 N*m{ 1,550 kgf*cm , 112 ft.*lbf } for steel wheel

   121 N*m{ 1,234 kgf*cm , 89 ft.*lbf } for aluminum wheel

1. Lower the vehicle.
   

2. Press down on the vehicle several times to stabilize the suspension.
   

1. Tighten the 2 nuts.
   

   Torque:

   210 N*m{ 2,141 kgf*cm , 155 ft.*lbf }

1. Fix the nut in place and tighten the bolt.
   

   Torque:

   95 N*m{ 969 kgf*cm , 70 ft.*lbf }

   NOTICE:

   Do not tighten the nut.