SHIFT LOCK SYSTEM > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK SHIFT LOCK OPERATION

  1. Move the shift lever to P.

  1. Turn the ignition switch OFF.

  1. Check that the shift lever cannot be moved to any position other than P.

  1. Turn the ignition switch ON, depress the brake pedal and check that the shift lever can be moved to other positions.



2. CHECK SHIFT LOCK RELEASE BUTTON OPERATION

  1. When operating the shift lever with the shift lock release button pressed, check that the lever can be moved to any position other than P.
    If the operation cannot be performed as specified, check the shift lever assembly.



3. CHECK KEY INTERLOCK OPERATION

  1. Turn the ignition switch ON.

  1. Depress the brake pedal and move the shift lever to any position other than P.

  1. Check that the ignition switch cannot be turned OFF.

  1. Move the shift lever to P, turn the ignition switch OFF and check that the key can be removed.
    If the results are not as specified, inspect the shift lock control unit.



4. CHECK SHIFT LOCK CONTROL ECU SUB-ASSEMBLY


C113154E01

  1. Measure the voltage of the connector.

    HINT:
    Do not disconnect the shift lock control ECU connector.

    Standard voltage:
    Tester Connection
    		Condition
    		Specified Condition
    S11-12 (KLS+) - S11-8 (E)
    		Ignition switch ACC and shift lever on P
    		Below 1 V
    S11-12 (KLS+) - S11-8 (E)
    		Ignition switch ACC and shift lever not on P
    		7.5 to 11 V
    S11-12 (KLS+) - S11-8 (E)
    		Ignition switch ACC and shift lever not on P (after approx. 1 second)
    		 6 to 9 V
    S11-6 (ACC) - S118 (E)
    		Ignition switch ON
    		10 to 14 V
    S11-6 (ACC) - S11-8 (E)
    		Ignition switch ACC
    		10 to 14 V
    S11-6 (ACC) - S11-8 (E)
    		Ignition switch OFF
    		Below 1 V
    S11-7 (STP) - S11-8 (E)
    		Depress brake pedal
    		10 to 14 V
    S11-7 (STP) - S11-8 (E)
    		Release brake pedal
    		Below 1 V
    S11-1 (IG) - S11-8 (E)
    		Ignition switch ON
    		10 to 14 V
    S11-1 (IG) - S11-8 (E)
    		Ignition switch OFF
    		Below 1 V



    C113154E02

  1. Measure the resistance of the connector.

    HINT:
    Do not disconnect the shift lock control ECU connector.

    Standard resistance:
    Tester Connection
    		Specified Condition
    S11-8 (E) - Body ground
    		Below 1 Ω

    If the result is not as specified, replace the shift lock control ECU sub-assembly.