SPEEDOMETER DRIVEN GEAR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE VEHICLE SPEED SENSOR WITH SPEEDOMETER DRIVEN GEAR SUB-ASSEMBLY


G022561

  1. Disconnect the sensor connector.

  1. Remove the bolt and sensor with the driven gear.



3. REMOVE SPEEDOMETER DRIVEN GEAR SUB-ASSEMBLY


C113235

  1. Remove the clip and driven gear from the sensor.



    C113234

  1. Remove the O-ring from the driven gear.