REAR BRAKE (for 2WD) > DISASSEMBLY

for Preparation Click here


HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.



1. DISCONNECT REAR BRAKE SHOE RETURN SPRING


C111396E01

  1. Using SST, disconnect the spring from the front brake shoe and rear brake shoe.

    SST
    09703-30011  

    NOTICE:
    Be careful not to damage the wheel cylinder boot.



2. REMOVE FRONT BRAKE SHOE


C111397E01

  1. Using SST, remove the shoe hold down spring cup, shoe hold down spring and pin.

    SST
    09718-00010  

  1. Remove the shoe and tension spring.



3. REMOVE PARKING BRAKE SHOE STRUT SET LH

  1. Remove the strut set from the rear brake shoe.



4. REMOVE REAR BRAKE SHOE


C111398E01

  1. Using SST, remove the shoe hold down spring cup, shoe hold down spring and pin.

    SST
    09718-00010  

  1. Using needle-nose pliers, remove the adjust lever tension spring from the automatic adjust lever. Then remove the shoe.



    C111480

  1. Using needle-nose pliers, disconnect the No. 3 parking brake cable from the parking brake shoe lever.



5. REMOVE REAR BRAKE AUTOMATIC ADJUST LEVER LH


C111481

  1. Using a screwdriver, remove the E-ring and lever.



6. REMOVE REAR BRAKE PARKING BRAKE SHOE LEVER SUB-ASSEMBLY


C111482

  1. Using a screwdriver, remove the C-washer and lever.



7. REMOVE REAR WHEEL BRAKE CYLINDER ASSEMBLY LH


C111485

  1. Using SST, disconnect the brake line.

    SST
    09023-00101  

  1. Remove the 2 bolts and cylinder.



8. REMOVE REAR WHEEL BRAKE CYLINDER CUP

  1. Remove the 2 cylinder dust boots from the cylinder.

  1. Remove the 2 pistons and compression spring.

  1. Remove the 2 cups from each piston.



9. REMOVE REAR BRAKE DRUM BLEEDER PLUG

  1. Remove the bleeder plug cap and bleeder plug from the cylinder.