BRAKE MASTER CYLINDER > REMOVAL

for Preparation Click here



1. DRAIN BRAKE FLUID

NOTICE:
Wash off brake fluid immediately if it comes in contact with any painted surface.



2. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY (w/o ABS)

  1. M/T:
    Disconnect the clutch reservoir tube labeled A from the master cylinder.

  1. Disconnect the brake fluid warning switch connector labeled B.



  1. Using SST, disconnect the 6 brake lines labeled C from the master cylinder and 4-way.

    SST
    09023-00101  


    C111291E01

  1. Remove the 2 nuts and bracket (with 4-way).

  1. Pull out the master cylinder from the brake booster.



  1. Remove the O-ring from the master cylinder.


    C111292E01



3. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY (w/ ABS)

  1. M/T:
    Disconnect the clutch reservoir tube labeled A from the master cylinder.

  1. Disconnect the brake fluid level warning switch connector labeled B.



  1. Using SST, disconnect the 5 brake lines labeled C from the master cylinder and 3-way.

    SST
    09023-00101  


    C111293E01

  1. Remove the 2 nuts and bracket (with 3-way).

  1. Pull out the master cylinder from the brake booster.



  1. Remove the O-ring from the master cylinder.


    C111294E01



4. REMOVE BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY

  1. Remove the screw.

  1. Remove the reservoir and 2 grommets from the master cylinder.