SPIRAL CABLE > REMOVAL

for Preparation Click here


CAUTION:
Be sure to read the precautionary notices concerning the SRS airbag system before servicing (Click here).



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE STEERING PAD ASSEMBLY


B112129E01

  1. Straighten the front wheels.

  1. Using a T30 "torx" socket, loosen the 2 screws until the groove along each screw circumference catches on the screw case.



    B085362E03

  1. Pull out the steering pad from the steering wheel and support the steering pad with one hand as shown in the illustration.

    NOTICE:
    When removing the steering pad, do not pull the airbag wire harness.

  1. Using a screwdriver, disconnect the airbag connector.

    CAUTION:
    When handling the airbag connector, do not damage the airbag wire harness.

  1. Disconnect the horn connector and remove the steering pad.



3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD


4. REMOVE STEERING WHEEL ASSEMBLY


G039068E01

  1. Remove the steering wheel set nut.

  1. Place matchmarks on the steering wheel and main shaft.

  1. Using SST, remove the steering wheel.

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05021)



5. REMOVE STEERING COLUMN COVER LOWER


H046251

  1. Remove the 3 screws and cover.



6. REMOVE STEERING COLUMN COVER UPPER


7. REMOVE SPIRAL CABLE SUB-ASSEMBLY


B110259E01

  1. Disconnect the connectors from the spiral cable.

    NOTICE:
    When handling the airbag connector, do not damage the airbag wire harness.

  1. Detach the 3 claws and remove the spiral cable.