AUDIO AND VISUAL SYSTEM > Radio Receiver Power Source Circuit

for Preparation Click here


DESCRIPTION

This circuit provides power to the radio receiver.

WIRING DIAGRAM


E106747E01


INSPECTION PROCEDURE

1.INSPECT FUSE (DCC, RAD, ACC)

  1. Remove the ACC fuse from the instrument panel junction block.

  1. Remove the DCC and RAD fuses from the engine room relay block.

  1. Measure the resistance of the fuses.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


2.CHECK WIRE HARNESS (RADIO RECEIVER ASSEMBLY - BATTERY AND BODY GROUND)
E106746E01

  1. Disconnect the R1 connector.

  1. Measure the voltage and resistance of the wire harness side connector.

    Standard voltage:
    Tester Connection
    		Condition
    		Specified Condition
    R1-4 (B) - Body ground
    		Always
    		10 to 14 V
    R1-3 (ACC) - Body ground
    		Ignition switch ACC
    		10 to 14 V

    Standard resistance:
    Tester Connection
    		Condition
    		Specified Condition
    R1-7 (GND) - Body ground
    		Always
    		Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE OR DIAGNOSTIC TROUBLE CODE CHART