ANTI-LOCK BRAKE SYSTEM > TC and CG Terminal Circuit

for Preparation Click here


DESCRIPTION

Connecting terminals TC and CG of the DLC3 causes the ECU to display DTCs through ABS warning light blinking patterns.

WIRING DIAGRAM


C108882E01


INSPECTION PROCEDURE

1.CHECK WIRE HARNESS (DLC3 - SKID CONTROL ECU AND BODY GROUND)
C108907E01

  1. Disconnect the S2 ECU connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    		Specified Condition
    D1-4 (CG) - Body ground
    		Below 1 Ω
    D1-13 (TC) - S2-16 (TC)
    		Below 1 Ω
    S2-16 (TC) - Body ground
    		10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE BRAKE ACTUATOR ASSEMBLY