DTC    C1251/51    Open in Pump Motor Circuit

for Preparation Click here


DESCRIPTION

The ABS pump motor is located inside the brake actuator.

DTC No.
DTC Detection Condition
Trouble Area
C1251/51
When one of following conditions is met:
  1. Actuator pump motor does not operate properly
  2. Actuator pump motor circuit remains open for at least 2 seconds
  1. Brake actuator
  2. Brake actuator circuit

WIRING DIAGRAM


C108862E02


INSPECTION PROCEDURE

1.PERFORM ACTIVE TEST BY INTELLIGENT TESTER (ABS MOTOR RELAY)

  1. Select the Active Test, generate a control command, and then check that the ABS motor relay operates.


Skid control ECU: 
Item
Vehicle Condition / Test Details
Diagnostics Note
ABS Motor Relay
Turn ABS motor relay ON / OFF
Operation sound of motor can be heard

OK:
Operation sound of ABS motor is heard.



OK
REPLACE BRAKE ACTUATOR ASSEMBLY
NG


2.CHECK WIRE HARNESS (SKID CONTROL ECU - BATTERY AND BODY GROUND)
C108884E06

  1. Disconnect the S2 ECU connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    		Specified Condition
    S2-2 (GND1) - Body ground
    		Below 1 Ω
    S2-24 (GND2) - Body ground
    		Below 1 Ω

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    		Specified Condition
    S2-23 (+BM) - Body ground
    		10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE BRAKE ACTUATOR ASSEMBLY