DTC    01-DD    Master Reset (AUDIO H/U)

for Preparation Click here


DESCRIPTION


DTC No.
DTC Detection Condition
Trouble Area
01-DD *
After engine was started, master component was disconnected from system.
  1. Wire harness
  2. Radio receiver assembly

HINT:
*: This code may be recorded depending on the battery condition or engine start voltage even if no faillure is detected.


INSPECTION PROCEDURE

1.CHECK POWER SOURCE CIRCUIT (RADIO RECEIVER ASSEMBLY)

  1. Please follow this pages (see page).

    HINT:
    If the power source circuit is operating normally, proceed to the next step.


NEXT


2.CHECK FOR DTC

  1. Delete the DTC.

  1. Check for DTCs again.

    OK:
    No DTC is output.



NG
REPLACE RADIO RECEIVER ASSEMBLY
OK

END