DTC    01-D6    No Master (AUDIO H/U)

for Preparation Click here


DESCRIPTION


DTC No.
DTC Detection Condition
Trouble Area
01-D6*
With ignition switch on ACC or ON, component in which this code is recorded was disconnected from system or master component.
  1. Wire harness
  2. Radio receiver assembly

HINT:
*: This code may be recorded depending on the battery condition or engine start voltage even if no failure is detected.


INSPECTION PROCEDURE

1.CHECK POWER SOURCE CIRCUIT (RADIO RECEIVER ASSEMBLY)

  1. Please follow this pages (see page).

    HINT:
    If the power source circuit is operating normally, proceed to the next step.


NEXT


2.CHECK FOR DTC

  1. Delete the DTC.

  1. Check for DTCs again.

    OK:
    No DTC is output.



NG
REPLACE RADIO RECEIVER ASSEMBLY
OK

END