AUDIO AND VISUAL SYSTEM > CD cannot be Inserted or is Ejected Right After Insertion

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK IF PROPER CD IS INSERTED

  1. Make sure that the CD is a normal audio CD, and that it is not deformed, flawed, stained, burred or otherwise defective.

    OK:
    Normal audio CD.

    HINT:
    Translucent or uniquely-shaped CDs cannot be played.



NG
CD IS FAULTY
OK


2.CHECK THAT CD IS INSERTED PROPERLY

  1. Check whether or not the CD is inserted upside down.

    OK:
    CD is properly inserted.



NG
INSERT CD PROPERLY
OK


3.CLEAN CD


    I100151

  1. Clean the disc by wiping the CD's underside radially with a soft cloth.

    OK:
    Malfunction disappears.

    NOTICE:
    Do not use a conventional record cleaner or anti-static preservative.



OK
CD WAS DIRTY
NG


4.REPLACE CD WITH ANOTHER AND RECHECK

  1. Replace the CD with a normal one and check if the same problem occurs again.

    OK:
    Malfunction disappears.



NG
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
OK

CD IS FAULTY