AUDIO AND VISUAL SYSTEM > Cassette Tape cannot be Ejected

for Preparation Click here


INSPECTION PROCEDURE

1.PRESS ''EJECT'' AND CHECK OPERATION

  1. Press the cassette tape EJECT switch of the radio receiver for 2 seconds or more and check that the cassette tape is ejected.

    OK:
    Cassette tape is ejected.



NG
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
OK


2.CHECK CASSETTE TAPE

  1. Check that the ejected cassette tape does not have a peeling label, cassette body deformation or other problems.

    OK:
    No problems with cassette tape.



NG
CASSETTE TAPE IS FAULTY
OK


3.REPLACE CASSETTE TAPE WITH ANOTHER AND RECHECK

  1. Replace the cassette tape with a normal one and check if the same problem occurs again.

    OK:
    Malfunction disappears.



NG
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
OK

CASSETTE TAPE IS FAULTY