ANTI-LOCK BRAKE SYSTEM > FREEZE FRAME DATA

for Preparation Click here



FREEZE FRAME DATA

HINT:
  1. When a DTC is detected or the ABS operates, the skid control ECU stores the current vehicle (sensor) state as freeze frame data.
  2. The skid control ECU stores the number of times (maximum: 31) the ignition switch has been turned from OFF to ON since the last time the ABS was activated. However, if the vehicle is stopped, the vehicle is driven at 7 km/h (4.3 mph) or less, or a DTC is detected, the ECU will not count the next time the ignition switch is turned from OFF to ON.
  3. Freeze frame data at the time the ABS operates:
    The skid control ECU stores data or updates stored data when the ABS operates. This data is erased when the ECU stores data at the time a DTC is detected.
  4. Freeze frame data at the time a DTC is detected:
    When the skid control ECU stores data at the time a DTC is detected, the data will not be updated until the data is cleared.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch ON.

  3. From the display on the tester, select Freeze Frame Data.

    Intelligent Tester Display
    		Measurement Item
    		Reference Value
    Freeze DTC
    		DTC recorded in freeze frame data
    		Min.: 0
    Max.: 255
    Vehicle Speed
    		Vehicle speed
    		Speed indication on meter
    Stop Light SW
    		Stop light switch signal
    		Stop light switch ON: ON
    Stop light switch OFF: OFF
    Number of IG ON
    		Number of ignition switch OFF to ON operations after memorizing freeze frame data
    		0 to 31
    Operated System
    		Information about system / mode status
    		No system activated: NO SYS
    ABS operating: ABS
    Fail-safe mode activated: FAIL SF
    G (Back and Forth)
    		Forward and rearward gravitational force (G)
    		Min.: -1.869
    Max.: 1.869