REAR PROPELLER SHAFT ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY (for 2WD)


F050137E01

  1. Place matchmarks on the propeller shaft flange and differential flange.

  1. Remove the 4 nuts, 4 bolts and 4 washers, and disconnect the propeller shaft.



    A098693E01

  1. Remove the center support bearing's 2 set bolts and 2 plates from the frame crossmember.



    C098710E01

  1. Pull out the propeller shaft.

  1. Install SST in the transmission to prevent oil leakage.

    SST
    09325-40010  



2. REMOVE PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY (for 4WD)


C098699E01

  1. Place matchmarks on the propeller shaft flange and transfer flange.

  1. Remove the 4 nuts, 4 bolts and 4 washers, and disconnect the propeller shaft.



    C098700E01

  1. Place matchmarks on the propeller shaft flange and differential flange.



    A098693E01

  1. Remove the 4 nuts, 4 bolts and 4 washers.

  1. Remove the center support bearing's 2 set bolts and 2 plates from the frame crossmember.

  1. Remove the propeller shaft.