ENGINE IMMOBILISER SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING


HINT:
  1. Use these procedures to troubleshoot the engine immobiliser system.
  2. *: Use the intelligent tester.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage :
      11 to 14 V

      1. If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.CRANK ENGINE FOR MORE THAN 10 SECONDS

      NEXT


      4.CHECK FOR DTC*

      1. Check for DTCs and note any codes that are output (Click here).

      2. Delete the DTC.

      3. Recheck for DTCs. Based on the DTC output above, try to force output of the same SFI, ECD or engine immobiliser system DTC by simulating the symptoms indicated by the DTC.

        Result: 
        Result
        		Proceed to
        DTC does not reoccur
        		A
        SFI system DTC reoccurs
        		B
        ECD system DTC reoccurs
        		C
        Engine immobiliser system DTC reoccurs
        		D



      		B.
      Go to SFI system

      		C.
      Go to ECD system

      		D.
      Go to step 7
      A


      5.PROBLEM SYMPTOMS TABLE

        Result: 
        Result
        		Proceed to
        Fault is not listed in problem symptoms table
        		A
        Fault is listed in problem symptoms table
        		B


      		B.
      Go to step 7
      A


      6.OVERALL ANALYSIS AND TROUBLESHOOTING*

      1. Data List/Active Test (Click here)

      2. Terminals of ECU (Click here)

      3. On-vehicle inspection (Click here)


      NEXT


      7.ADJUST, REPAIR OR REPLACE

        NEXT


        8.CONFIRMATION TEST

          NEXT

          END