DRIVE BELT > INSTALLATION

for Preparation Click here



1. INSTALL DRIVE BELT


    A097752E02

  1. Install the drive belt to the pulleys except the drive belt tensioner pulley.

  1. Use the hexagon-shaped part indicated by the arrow in the illustration to move the tensioner pulley downward and then install the drive belt to the tensioner pulley.

    NOTICE:
    1. The backside of the drive belt should face the tensioner pulley.
    2. Check that the drive belt is properly set to each pulley.



    G038479E01

  1. After a new belt has been installed, check that the tensioner indicator mark is within range A shown in the illustration.